Mitac 168 and TT5 navigator problems

oka · #1 (**permalink**) 23-11-2005, 02:12 PM

Please help me.....

Hi, i seem to be having a problem. Battery went dead on Mitac Mio 168, recharged and placed Tomtom navigator 5 SD card into unit. All seemed fine but when i drive my car i am not being picked up by GPS once i start driving. it seems to be fine when stationary but whilst driving it always seems to be plotting another route as it seems that the GPS can't keep up with me, (even though i have a full GPS signal, using other cable nmea gps or TomTom gps). Also once GPS has locked on, any commands with the Tomtom menu seem to take 45-60 seconds to work.
Have tried hard and soft resets to no avail.
Does anyone else have this problem?
Does anyone know if i need to change any settings anywhere?

Please help or this could end up on a motorway near you soon!

**Stevie** · #2 (**permalink**) 23-11-2005, 04:02 PM

have you selected serial cable on sp2 in the com port section?

oka · #3 (**permalink**) 24-11-2005, 02:53 PM

Quote:

Originally Posted by Stevie

have you selected serial cable on sp2 in the com port section?

Yes, sp2 and baud rate 4800