TomTom3 Bluetooth settings

Hi !
This might be a dumb question but I have to ask. I can't fins out the right settings for tomtom to comunicate with my BT GPS reciver. It's a reciver called roadnav rn-600.
When I connect my Ipaq to the reciver with BT I found a device called "SPP slave" I bound my ipaq with it and both the ipaq and reciver indicates there is a bluetooth connection. And there is now my problem starts. The reciver indicates it's have contact with one or more GPS sattelites. BUT.... when I start tomtom he says that that he can't determine a correct GPS location.

I have no idé how to setup the gps in tomtom, I think I have tried all the possible combinations. If I look at the tech spec of my reciver it has support for nmea 0183 with 3800 baud.

When looking in the settings in tomtom I can use alot of different nmea 0183 connections. I have tried: nmea 0183v2 bluetooth with "serial cabel on BT" bluetooth serial port com6, 7 and 8.

I have tried nmea 0183v2 38400 with the same "ports"

The reciver shuld also have support for SIRF, I have tried that to.

What am I doing wrong? what settings huld I use? Can't I use my reciver with tomtom? is there something wong with the install so I have to reinstall tomtom?

//Oscar

[Charlie]

Welcome to our forums.
Try selecting TomTom Wireless GPS & Bluetooth Serial Port COM(?)
The "?" depends on what COM ports you have available.

I have:
com3
com5
Serial Cabel on com1
Bluetooth Serial port8
Bluetooth Serial port7
Bluetooth Serial port6

(this isn't a reciver bought from tomtom)

[Charlie]

Try each Bluetooth port in turn....it depends which PDA you have?

I have tried all of them, how can I verfy that tomtom has contact with the gps reciver? I have an ipaq 3970

Have you "bonded" your GPS reciever with your PDA?

[Charlie]

In the STATUS page of TomTom GPS you will get dots moving when you have an active connection with the receiver.