TomTom Wired GPS receiver pinout needed

Hi,

TomTom Wired GPS Receiver Pinout needed (connector pinout);

can somebody help me?



Thanks,
George

[Charlie]

should be:

1. NC
2. +5V
3. RX
4. TX
5. GND
6. NC

Charlie, i dont suppose you could elaborate on the colour assignments could you?
I have an original tomtom wired gps (leadtek - SirfXtrac i believe).
The Cable on the GPS only has 3 conductors (Red,Brown and Orange).

I have tried to connect them up to the tomtom mount as A1,A2 and A3 but all i get is
'No GPS Device'

Any help would be much appreciated

RGs
Paul

Hi,
I also have just had this problem with my IPAQ 2210 and the wired GPS connection to the cradle. About 3 weeks ago it was (literally) hanging by a thread. At work I have the tools needed to crimp a new end, but I have just done that and get no GPS device as well.
Like 'PaulRyan' I have Red,Brown and Orange, but I think they go to A2,A3 and A4 (A1 had a 'filler' conductor in it).
I can normally test cables at work, but I cant with the GPS receiver on the end.

Any help would really be appreciated as it is out of action at the moment

Thanks
Graham

[Martin Laverty]

I think this atachment covers what yor after.

Originally Posted by Wools

Hi,
I also have just had this problem with my IPAQ 2210 and the wired GPS connection to the cradle. About 3 weeks ago it was (literally) hanging by a thread. At work I have the tools needed to crimp a new end, but I have just done that and get no GPS device as well.
Like 'PaulRyan' I have Red,Brown and Orange, but I think they go to A2,A3 and A4 (A1 had a 'filler' conductor in it).
I can normally test cables at work, but I cant with the GPS receiver on the end.

Any help would really be appreciated as it is out of action at the moment

Thanks
Graham

Check the world's largest pinouts archive: AllPinouts ( AllPinouts - Connectors, Cables and Adapters Pinouts ), they have a lot of GPS pinouts: Category:GPS Connectors - AllPinouts