TTN5 and Haicom HI-303MMFGPS

#1 (**permalink**) 18-06-2005, 09:29 PM

I purchased the Haicom HI-303MMF CF GPS receiver from Total PDA on advise from sales, it was to use with Ipaq 2210 and TTN5.

I have found that it will work on my 2210 but not with TTN5, it wont pick up a GPS signal.

I tested it on TTN 4.4 and it worked ok, seams it is not compatible with ver 5.

Seen a few posts on other forums with the same problem.

Can anyone whwlp with this..?

**Stevie** · #2 (**permalink**) 20-06-2005, 08:34 AM

When you go into the GPS setup and click on configure.

Select other cabled NMEA, baud 4800 and then tell me what com ports are available.

#3 (**permalink**) 20-06-2005, 09:53 AM

I have the following

CF_Card GE
COM3
IR
COM6
Serial Cable on COM1
Serial Cable on DT
Serial on USB
Bluetooth serial

if i select CF_Card GE the UTC clock starts but never get any saellites of valid gps signal...

If i roll back my version of tomtom to 4.4 it works fine.

#4 (**permalink**) 21-06-2005, 11:44 AM

did you manage to get a responce out of tomtom after our conversation yesterday....?